[meta-freescale] Yocto not booting on i.mx233 Custom Board

[Fabio Estevam]

On Mon, Apr 29, 2013 at 1:06 PM, Yanir Hirshberg
<yanir at summitappliance.com> wrote:
> Fabio, thanks for the quick response.
>
> Can you please be a little more specific. I am new to using uboot. How would
> I change these settings?

You need to look at the U-boot source (board/freescale/mx23evk/spl_boot.c ) :

	/* MMC 0 */
	MX23_PAD_SSP1_DATA0__SSP1_DATA0 | MUX_CONFIG_SSP1,
	MX23_PAD_SSP1_DATA1__SSP1_DATA1 | MUX_CONFIG_SSP1,
	MX23_PAD_SSP1_DATA2__SSP1_DATA2 | MUX_CONFIG_SSP1,
	MX23_PAD_SSP1_DATA3__SSP1_DATA3 | MUX_CONFIG_SSP1,
	MX23_PAD_SSP1_CMD__SSP1_CMD | MUX_CONFIG_SSP1,
	MX23_PAD_SSP1_DETECT__SSP1_DETECT | MUX_CONFIG_SSP1,
		(MXS_PAD_8MA | MXS_PAD_3V3 | MXS_PAD_NOPULL),
	MX23_PAD_SSP1_SCK__SSP1_SCK |
		(MXS_PAD_8MA | MXS_PAD_3V3 | MXS_PAD_NOPULL),
	/* Write Protect Pin */
	MX23_PAD_PWM4__GPIO_1_30 |
		(MXS_PAD_4MA | MXS_PAD_3V3 | MXS_PAD_NOPULL),
	/* Slot Power Enable */
	MX23_PAD_PWM3__GPIO_1_29 |
		(MXS_PAD_4MA | MXS_PAD_3V3 | MXS_PAD_NOPULL),

Then you need to use the pins that your custom boards uses.

As this a purely U-boot related issue, it would be better if you could
post it in the U-boot list.

Regards,

Fabio Estevam