[meta-ti] [PATCH 1/2] u-boot 2011.09: convert beagleboard to SPL build

[Tom Rini]

On Wed, Dec 7, 2011 at 6:13 PM, Andreas Müller <schnitzeltony at gmx.de> wrote:
> On Sunday, November 27, 2011 04:03:37 PM Koen Kooi wrote:
>> Runtime tested on an xM rev C
>>
>> Signed-off-by: Koen Kooi <koen at dominion.thruhere.net>
>> ---
>>  ...-probe-DDC-bus-for-expansionboard-EEPROMS.patch |  165 ----------
>>  ...p3-mem-Comment-enable_gpmc_cs_config-more.patch |   56 ++++
>>  ...e-SDRC-dram_init-to-always-call-make_cs1_.patch |   66 ++++
>>  ...-a-helper-function-to-set-timings-in-SDRC.patch |  172 +++++++++++
>>  ...e-mem_ok-to-clear-again-after-reading-bac.patch |   30 ++
>>  .../0005-OMAP3-Remove-get_mem_type-prototype.patch |   28 ++
>>  .../0006-omap3-mem-Add-MCFG-helper-macro.patch     |   97 ++++++
>>  ...d-optimal-SDRC-autorefresh-control-values.patch |   59 ++++
>>  ...x-all-Micron-memory-timing-parts-with-the.patch |   55 ++++
>>  ...ework-memory-initalization-and-devkit8000.patch |  174 +++++++++++
>>  ...OMAP3-SPL-Add-identify_nand_chip-function.patch |  142 +++++++++
>>  ...0011-OMAP3-Add-SPL-support-to-Beagleboard.patch |  315
> Is anybody working on SPL support for gumstix overo?

No, but in mainline U-Boot it should be very easy to do so and I'd be
glad to help out with questions on the SPL specific side of things
(basically overo needs to provide a function that returns the correct
timings for the SDRC for the board rev in question).

-- 
Tom