[meta-ti] Building Yocto for Pandaboard

[Marc Butler]

On Mon, Mar 05, 2012 at 12:13:59PM -0500, Robert P. J. Day wrote:
> On Mon, 5 Mar 2012, Denys Dmytriyenko wrote:
> 
> > On Mon, Mar 05, 2012 at 09:43:13AM -0700, Gary Thomas wrote:
> > > On 2012-03-05 09:39, Robert P. J. Day wrote:
> > > >On Mon, 5 Mar 2012, Christian.Schulenberg at bmw.de wrote:
> > > >
> > > >>Hi,
> > > >>
> > > >>I'm using a Pandaboard Rev A4, so it is in fact an OMAP4430 board.
> > > >>
> > > >>You can change to u-boot bootloader in /meta-ti/conf/machine/omap4430-panda.conf:
> > > >
> > > >   i noticed that koen just submitted a sizable patch that gets rid of
> > > >that conf file for the panda, and standardizes on the pandaboard.conf
> > > >file (at least that's what it looked like).
> > > >
> > > >   under the circumstances, it might be worth just waiting until that
> > > >patch works its way through the system and start testing all over
> > > >again when it hits.
> > >
> > > Yes, you'll also get a newer kernel (3.0.2 last I looked, not 2.6.35)
> >
> > FYI, there is already 3.1 for Panda in meta-ti with -1 D_P...
> 
>   ok, i can see the new content and i just pulled into meta-ti and
> meta-openembedded.  so, starting all over again, is there now a
> known recipe for building for the panda with a minimum of
> customziation?
> 
>   i think i'm going to start a new wiki page. :-)

If this works for you, I would be eager to know the process. And happy
to verify in another environment.

-m