[meta-ti] Booting failed
deepak vijay
deepakvijay2255 at rediff.com
Fri May 9 03:31:02 PDT 2014
Hi,
When I configured Low level debugging and earlyprintk in bootargs I am
getting the following output logs of crashing.
U-Boot SPL 2011.12 (May 08 2014 - 15:01:46)
Texas Instruments Revision detection unimplemented
OMAP SD/MMC: 0
reading u-boot.img
reading u-boot.img
U-Boot 2011.12 (May 08 2014 - 15:01:46)
OMAP36XX/37XX-GP ES1.2, CPU-OPP2, L3-165MHz, Max CPU Clock 1 Ghz
OMAP3 EVM board + LPDDR/NAND
I2C: ready
DRAM: 256 MiB
NAND: 512 MiB
MMC: OMAP SD/MMC: 0
In: serial
Out: serial
Err: serial
Read back SMSC id 0x92200000
Die ID #706a00029ff80000016842c911024007
Net: smc911x-0
Hit any key to stop autoboot: 0
reading boot.scr
** Unable to read "boot.scr" from mmc 0:1 **
reading uImage
3214968 bytes read
Booting from mmc ...
## Booting kernel from Legacy Image at 82000000 ...
Image Name: Linux-2.6.37
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 3214904 Bytes = 3.1 MiB
Load Address: 80008000
Entry Point: 80008000
Verifying Checksum ... OK
Loading Kernel Image ... OK
OK
Starting kernel ...
********Using machid 0x5ff from environment
Uncompressing Linux... done, booting the kernel.
[ 0.000000] Linux version 2.6.37 (mistral at CPU000512U) (gcc version 4.8.2
(GCC) ) #2 Fri May 9 14:42:06
IST 2014
[ 0.000000] CPU: ARMv7 Processor [413fc082] revision 2 (ARMv7),
cr=10c53c7d
[ 0.000000] CPU: VIPT nonaliasing data cache, VIPT aliasing instruction
cache
[ 0.000000] Machine: OMAP3 EVM
[ 0.000000] bootconsole [earlycon0] enabled
[ 0.000000] Reserving 4194304 bytes SDRAM for VRAM
[ 0.000000] Memory policy: ECC disabled, Data cache writeback
[ 0.000000] OMAP3630 ES1.2 (l2cache iva sgx neon isp 192mhz_clk )
[ 0.000000] SRAM: Mapped pa 0x40200000 to va 0xfe400000 size: 0x10000
[ 0.000000] Built 1 zonelists in Zone order, mobility grouping on.
Total pages: 64000
[ 0.000000] Kernel command line: console=ttyO0,115200n8 earlyprintk
root=/dev/mmcblk0p2 rw rootfstype=
ext3 rootwait
[ 0.000000] PID hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.000000] Dentry cache hash table entries: 32768 (order: 5, 131072
bytes)
[ 0.000000] Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
[ 0.000000] Memory: 252MB = 252MB total
[ 0.000000] Memory: 242156k/242156k available, 19988k reserved, 0K
highmem
[ 0.000000] Virtual kernel memory layout:
[ 0.000000] vector : 0xffff0000 - 0xffff1000 ( 4 kB)
[ 0.000000] fixmap : 0xfff00000 - 0xfffe0000 ( 896 kB)
[ 0.000000] DMA : 0xffc00000 - 0xffe00000 ( 2 MB)
[ 0.000000] vmalloc : 0xd0800000 - 0xf8000000 ( 632 MB)
[ 0.000000] lowmem : 0xc0000000 - 0xd0000000 ( 256 MB)
[ 0.000000] modules : 0xbf000000 - 0xc0000000 ( 16 MB)
[ 0.000000] .init : 0xc0008000 - 0xc003c000 ( 208 kB)
[ 0.000000] .text : 0xc003c000 - 0xc05eda00 (5831 kB)
[ 0.000000] .data : 0xc05ee000 - 0xc07afb60 (1799 kB)
[ 0.000000] Unable to handle kernel paging request at virtual address
8002f130
[ 0.000000] pgd = c0004000
[ 0.000000] [8002f130] *pgd=00000000
[ 0.000000] Internal error: Oops: 805 [#1]
[ 0.000000] last sysfs file:
[ 0.000000] Modules linked in:
[ 0.000000] CPU: 0 Not tainted (2.6.37 #2)
[ 0.000000] PC is at perf_pmu_register+0x12c/0x178
[ 0.000000] LR is at lockdep_init_map+0xb0/0x448
[ 0.000000] pc : [<c00ca3e4>] lr : [<c009bcd0>] psr: a00001d3
[ 0.000000] sp : c05eff90 ip : 00000000 fp : c05effd4
[ 0.000000] r10: 0000001f r9 : 413fc082 r8 : 000003f8
[ 0.000000] r7 : c0605750 r6 : c05eff68 r5 : c0f4b010 r4 : c05eff68
[ 0.000000] r3 : 8002f12c r2 : c07789dc r1 : c0548676 r0 : 00000001
[ 0.000000] Flags: NzCv IRQs off FIQs off Mode SVC_32 ISA ARM
Segment kernel
[ 0.000000] Control: 10c5387d Table: 80004019 DAC: 00000017
[ 0.000000] Process swapper (pid: 0, stack limit = 0xc05ee2f0)
[ 0.000000] Stack: (0xc05eff90 to 0xc05f0000)
[ 0.000000] ff80: c0778ba0 c07b0c40
c07b0c40 c0018588
[ 0.000000] ffa0: c05ee000 c0015784 3b9aca00 00000000 00000000 00000001
c0030bb0 c07afb80
[ 0.000000] ffc0: c0030bb0 c0f49100 c05f2d0c 8002f12c 00000000 c0008a0c
c000866c 000005ff
[ 0.000000] ffe0: 80000100 c0030bb0 10c53c7d c07afd34 c0030bac 80008034
00000000 00000000
[ 0.000000] [<c00ca3e4>] (perf_pmu_register+0x12c/0x178) from
[<c0018588>] (perf_event_init+0x3c/0xa4)
[ 0.000000] [<c0018588>] (perf_event_init+0x3c/0xa4) from [<c0015784>]
(sched_init+0x200/0x24c)
[ 0.000000] [<c0015784>] (sched_init+0x200/0x24c) from [<c0008a0c>]
(start_kernel+0x124/0x2d0)
[ 0.000000] [<c0008a0c>] (start_kernel+0x124/0x2d0) from [<80008034>]
(0x80008034)
[ 0.000000] Code: e59f204c e5843000 e5842004 e2422064 (e5834004)
[ 0.000000] irq 56, desc: c0769a24, depth: 1, count: 0, unhandled: 0
[ 0.000000] ->handle_irq(): c00adad0, handle_bad_irq+0x0/0x224
[ 0.000000] ->irq_data.chip(): (null), 0x0
[ 0.000000] ->action(): (null)
[ 0.000000] IRQ_DISABLED set
[ 0.000000] IRQ_NOPROBE set
[ 0.000000] IRQ_NOREQUEST set
[ 0.000000] Unable to handle kernel NULL pointer dereference at virtual
address 00000000
[ 0.000000] pgd = c0004000
[ 0.000000] [00000000] *pgd=00000000
[ 0.000000] Internal error: Oops: 5 [#2]
[ 0.000000] last sysfs file:
[ 0.000000] Modules linked in:
[ 0.000000] CPU: 0 Tainted: G D (2.6.37 #2)
[ 0.000000] PC is at handle_bad_irq+0x1a0/0x224
[ 0.000000] LR is at handle_bad_irq+0x184/0x224
[ 0.000000] pc : [<c00adc70>] lr : [<c00adc54>] psr: 400001d3
[ 0.000000] sp : c05efd28 ip : ffffffff fp : c00ca3e4
[ 0.000000] r10: 00000017 r9 : 00000000 r8 : c05ee000
[ 0.000000] r7 : c00ca3e6 r6 : 00000000 r5 : c078114c r4 : c0769a24
[ 0.000000] r3 : 00000000 r2 : 00000000 r1 : c05efc40 r0 : 00000025
[ 0.000000] Flags: nZcv IRQs off FIQs off Mode SVC_32 ISA ARM
Segment kernel
[ 0.000000] Control: 10c5387d Table: 80004019 DAC: 00000017
[ 0.000000] Process swapper (pid: 0, stack limit = 0xc05ee2f0)
[ 0.000000] Stack: (0xc05efd28 to 0xc05f0000)
[ 0.000000] fd20: 00000000 00000000 00000038 c003c070
ffffffff fa200000
[ 0.000000] fd40: 00000001 c043c6b8 c043bee4 c05efd70 00000000 00000001
c05f2f30 c05efdda
[ 0.000000] fd60: 00000001 c00ca3e6 c05ee000 00000000 00000017 c00ca3e4
ffffffff c05efd90
[ 0.000000] fd80: c043bee4 c043bee8 60000153 ffffffff c05eff48 c0049800
c05ee2f0 0000000b
[ 0.000000] fda0: 00000000 00000008 655f14a8 32663935 20633430 34383565
30303033 38356520
So from this I believe that it is because of kernel paging problem.
Please help me to resolve this.
Regards,
Deepak
On Thu, May 8, 2014 at 3:45 PM, deepak vijay <deepakvijay2255 at rediff.com>wrote:
> Hi,
> I have build omap3evm images by including mata-ti layer.
> When I am trying to boot the omap3evm board it is stuck at "Uncompressing
> Linux... done, booting the kernel" this comment.
> Can any one help me to over come this issue.
> The boot logs are given below.
> U-Boot SPL 2011.12 (May 08 2014 - 15:01:46)
> Texas Instruments Revision detection unimplemented
> OMAP SD/MMC: 0
> reading u-boot.img
> reading u-boot.img
>
>
> U-Boot 2011.12 (May 08 2014 - 15:01:46)
>
> OMAP36XX/37XX-GP ES1.2, CPU-OPP2, L3-165MHz, Max CPU Clock 1 Ghz
> OMAP3 EVM board + LPDDR/NAND
> I2C: ready
> DRAM: 256 MiB
> NAND: 512 MiB
> MMC: OMAP SD/MMC: 0
> *** Warning - bad CRC, using default environment
>
> In: serial
> Out: serial
> Err: serial
> Read back SMSC id 0x92200000
> Die ID #706a00029ff80000016842c911024007
> Net: smc911x-0
> Hit any key to stop autoboot: 0
> reading boot.scr
>
> ** Unable to read "boot.scr" from mmc 0:1 **
> reading uImage
>
> 3139340 bytes read
> Booting from mmc ...
> ## Booting kernel from Legacy Image at 82000000 ...
> Image Name: Linux-2.6.37
> Image Type: ARM Linux Kernel Image (uncompressed)
> Data Size: 3139276 Bytes = 3 MiB
> Load Address: 80008000
> Entry Point: 80008000
> Verifying Checksum ... OK
> Loading Kernel Image ... OK
> OK
>
> Starting kernel ...
>
> Uncompressing Linux... done, booting the kernel.
>
>
> Regards,
> Deepak Vijay
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.yoctoproject.org/pipermail/meta-ti/attachments/20140509/1dac8c13/attachment-0001.html>
More information about the meta-ti
mailing list