[meta-xilinx] Bitstream/Boot.bin/etc - Providers/Virtual targets
Mike Looijmans
mike.looijmans at topic.nl
Wed Feb 19 06:02:24 PST 2014
Where should I post (git) patches for u-boot?
There are a few bugs that need fixing, and some of them I can probably fix myself.
One major thing is that the SPL build fails without CONFIG_SPL_FPGA_SUPPORT
defined.
A minor issue is this one:
mmc boot
reading fpga.bin
spl: error reading image system.dtb, err - -1
A simple copy/paste error that causes the wrong message to be displayed.
Maybe there's more...
On 02/19/2014 11:16 AM, Michal Simek wrote:
>>>>> What if I boot from flash? (usually I run the bootloader from flash and
>>>>> the image from either flash or SD)
>>>>
>>>> I'm not sure. Michal?
>>>
>>> Just look at the code and you will see.
>>> For SD there is a mode which I am using which is loading u-boot.img from
>>> FAT partition on SD. There is also mode where images doesn't need to be
>>> on FAT but RAW mode can be used.
>>
>> On flash, the most logical thing to do would be to put the "img" part right behind the SPL part. The linker can fill in the offset. I think that's what other SPL boots (like OMAP) do, it's been awhile since i hacked in those.
>
> There are several configurations. For me is just better to have this separated
> because I can just upgrade full u-boot and not spl and boot.bin.
> If you check code there is everything in place for it - just set it up.
>
> Thanks,
> Michal
>
Met vriendelijke groet / kind regards,
Mike Looijmans
TOPIC Embedded Systems
Eindhovenseweg 32-C, NL-5683 KH Best
Postbus 440, NL-5680 AK Best
Telefoon: (+31) – (0)499 - 33.69.79
Telefax: (+31) - (0)499 - 33.69.70
E-mail: mike.looijmans at topic.nl
Website: www.topic.nl
Dit e-mail bericht en de eventueel daarbij behorende bijlagen zijn uitsluitend bestemd voor de geadresseerde, zoals die blijkt uit het e-mail bericht en/of de bijlagen. Er kunnen gegevens met betrekking tot een derde instaan. Indien u als niet-geadresseerde dit bericht en de bijlagen ontvangt, terwijl u niet bevoegd of gemachtigd bent om dit bericht namens de geadresseerde te ontvangen, wordt u verzocht de afzender hierover direct te informeren en het e-mail bericht met de bijlagen te vernietigen. Ieder gebruik van de inhoud van het e-mail bericht, waaronder de daarbij behorende bijlagen, door een ander dan de geadresseerde is onrechtmatig jegens ons dan wel de eventueel in het e-mail bericht of de bijlagen voorkomende andere personen. TOPIC Embedded Systems is niet aansprakelijk voor enigerlei schade voortvloeiend uit het gebruik en/of acceptatie van dit e-mail bericht of de daarbij behorende bijlagen.
The contents of this message, as well as any enclosures, are addressed personally to, and thus solely intended for the addressee. They may contain information regarding a third party. A recipient who is neither the addressee, nor empowered to receive this message on behalf of the addressee, is kindly requested to immediately inform the sender of receipt, and to destroy the message and the enclosures. Any use of the contents of this message and/or the enclosures by any other person than the addressee or person who is empowered to receive this message, is illegal towards the sender and/or the aforementioned third party. TOPIC Embedded Systems is not liable for any damage as a result of the use and/or acceptance of this message and as well as any enclosures.
More information about the meta-xilinx
mailing list