[meta-xilinx] U-boot SPL and NAND support for the zynq
Mike Looijmans
mike.looijmans at topic.nl
Tue Sep 2 04:20:13 PDT 2014
We've discussed u-boot SPL on this board before, so I expect my intended
audience to be here.
Has anyone here used Zynq NAND support in u-boot? And SPL?
The status a few months ago appeared to be that NAND would work, but SPL did
not compile because of missing source files. I could boot from SD and then
address the NAND device though, which was enough for that day as I just wanted
to verify the NAND chip was wired and soldered correctly.
I tried upgrading u-boot to the status quo today, and to my surprise, u-boot
fails to build (linker error) when I enable CONFIG_NAND_ZYNQ:
| LD spl/u-boot-spl
| arm-oe-linux-gnueabi-ld.bfd:u-boot-spl.lds:1: ignoring invalid character `#'
in expression
| arm-oe-linux-gnueabi-ld.bfd:u-boot-spl.lds:1: syntax error
| make[1]: *** [spl/u-boot-spl] Error 1
Met vriendelijke groet / kind regards,
Mike Looijmans
TOPIC Embedded Systems
Eindhovenseweg 32-C, NL-5683 KH Best
Postbus 440, NL-5680 AK Best
Telefoon: (+31) (0) 499 33 69 79
Telefax: (+31) (0) 499 33 69 70
E-mail: mike.looijmans at topic.nl
Website: www.topic.nl
Please consider the environment before printing this e-mail
Bezoek ons op 9 en 10 september tijdens Technology for Health Den Bosch (stand 53)
http://www.technologyforhealth.nl
More information about the meta-xilinx
mailing list