[meta-xilinx] picozed

[Harold Lapprich]

Hi Jeff,

Brought the Avnet PicoZed up on the Avnet FMC carrier card 6 months ago and used the u-boot from their BSP petalinux. It work great (eMMC functionality and all). Here are several URL for the Avnet PicoZed/FMC Carrier Board petalinux/u-boot:

Everything we have is here
http://zedboard.org/support/documentation/4701

here
http://zedboard.org/support/documentation/4736

and finally here,  there is eMMC at this link 

http://zedboard.org/support/design/4736/71

Harold


-----Original Message-----
From: meta-xilinx-bounces at yoctoproject.org [mailto:meta-xilinx-bounces at yoctoproject.org] On Behalf Of Jeff Hagen
Sent: Monday, August 10, 2015 4:37 PM
To: meta-xilinx at yoctoproject.org
Subject: [meta-xilinx] picozed


Has anyone tried the picozed-zynq7 machine target in poky-fido?
Would I expect that to work?

I can check it out and build it as per the directions in doc/BOOT.sdcard but I cant seem to find a u-boot that works. The default boot.bin gives the interesting console error "Unsuported boot mode" like the picozed patch hasnt been applied (looking at spl.c). Yet config/zynq_picozed.h has configs defined. Elsewhere picozed.h is empty. I dont see any obvious errors in the logs.

I did try to make a BOOT.BIN as per the directions  using the xilinx bootgen. That just hangs with no messages. It looks like the bit file loads,  and u-boot hangs.

I am using the FMC carrier board to hold the flash. Perhaps this is not supported.

I have had good success with BOOT.BIN, u-boot and bootgen in poky-dora on microzed, but I'm no expert.
Did I miss something dumb?

Thanks,

Jeff

--
Jeffrey R Hagen
Lithe Technology LLC
jhagen at lithetechnology.com
(520) 488-1155 (mobile)
(520) 621-4771 (office)
http://www.lithetechnology.com

--
_______________________________________________
meta-xilinx mailing list
meta-xilinx at yoctoproject.org
https://lists.yoctoproject.org/listinfo/meta-xilinx