[meta-xilinx] Getting eth1 going

[Peter Crosthwaite]

On Fri, Nov 20, 2015 at 10:21 AM, Philip Balister <philip at balister.org> wrote:
> I'm working with a zedboard and an ethernet FMC card to look at using 2
> ethernet interfaces. (http://ethernetfmc.com/)
>
> I'm using recent mainline Linux with the cadence driver. There was a
> thread here a while back that ended with this message:
>
> [   27.939848] macb e000c000.ethernet eth1: unable to generate target
> frequency: 125000000 Hz 0
>
> The 0 on the back is the calculated clock. Has anyone solved this issue?
> Will the cadence driver work as eth1?
>

Can you paste the dts nodes for eth1? Does the clock nodes and
properties look symmetric with eth0?

Also, if there are nodes that are reffed by the clock lists then worth
pasting those too.

Regards,
Peter

> Philip
> --
> _______________________________________________
> meta-xilinx mailing list
> meta-xilinx at yoctoproject.org
> https://lists.yoctoproject.org/listinfo/meta-xilinx