[yocto] e100 driver does not build

[Bruce Ashfield]

On 11-08-31 7:18 PM, Tom Zanussi wrote:
>
> On Wed, 2011-08-31 at 16:04 -0700, Saxena, Rahul wrote:
>> I am unable to get the e100 driver to build for my BSP.
>>
>> I have configured to build it as a module. I do  not see the e100.ko
>> file being generated nor does
>>
>>   CONFIG_E100 appear in the generated .config file in my build area.
>>
>>
>>
>> However I do see the driver source file e100.c in
>>    tmp/work/bspname-poky-linux/linux-yocto-3.0.3+git1
>> +xxxx ../linux/drivers/net
>>
>>
>>
>> I do not have any problems with other drivers (igb, E1000 etc)  that I
>> have configured in exactly similar way.
>>
>>
>>
>> Any insight on this issue ?
>>
>
> It's probably missing another option it depends on e.g. is
> CONFIG_NET_PCI and CONFIG_MII enabled in your .config?

This is most likely what it is.

Out of curiosity, how did you enable the option ? Via a config fragement
(.cfg file) or via menuconfig .. or something else?

If you tried to set something via a fragment and it doesn't make it to
the final .config, you should see a warning during the kernel build
phase.

Cheers,

Bruce

>
> Tom
>
>>
>>
>> Thanks
>>
>> Rahul
>>
>>
>
>
> _______________________________________________
> yocto mailing list
> yocto at yoctoproject.org
> https://lists.yoctoproject.org/listinfo/yocto