[yocto] Wireshark but no Tshark?

[Gary Thomas]

On 2017-06-12 19:19, Michael Calve wrote:
> I was able to create a username and password, and use this as credentials for SSH.  However, I can't run some of the 
> commands that I can when using picocom, and thus operating as root.

Such as?

> 
> On Mon, Jun 12, 2017 at 10:34 AM, Michael Calve <michael.calve at vectare.com <mailto:michael.calve at vectare.com>> wrote:
> 
>     Okay thank you very much for the clarification.
> 
>     Is there a set password for the root username?  I'm attempting to send files across and run scripts abord the joule
>     from my host system!
> 
>     On Mon, Jun 12, 2017 at 3:50 AM, Jussi Kukkonen <jussi.kukkonen at intel.com <mailto:jussi.kukkonen at intel.com>> wrote:
> 
>         On 7 June 2017 at 20:59, Michael Calve <michael.calve at vectare.com <mailto:michael.calve at vectare.com>> wrote:
> 
>             Hi, I've seen that Wireshark is portable to Yocto, however Tshark is not?  Is there other/better software
>             for reading pcaps and getting field data???
> 
> 
>         Hi,
> 
>         tshark is part of wireshark: it should be built by the wireshark recipe in meta-networking.
> 
>         If you want a smaller footprint tool, try tcpdump (also in meta-networking). It's not as featureful as tshark
>         but uses the same sniffing library and wireshark can display tcpdump results just fine.
> 
>         Jussi
> 
> 
> 
> 
> 


-- 
------------------------------------------------------------
Gary Thomas                 |  Consulting for the
MLB Associates              |    Embedded world
------------------------------------------------------------