[yocto] core-image-* (minimal) networking
Peter Balazovic
balazovic.peter at gmail.com
Sun Dec 16 23:51:56 PST 2018
> ifconfig eth0 up
> udhcpc -ieth0
Now is up ... and identified and now trying to figure out how to make it
permanent since after reboot I need to do over again.
On Mon, Dec 17, 2018 at 5:30 AM Khem Raj <raj.khem at gmail.com> wrote:
> On Fri, Dec 14, 2018 at 8:23 AM Peter Balazovic
> <balazovic.peter at gmail.com> wrote:
> >
> > I've built bitbake core-image-minimal and it runs but unfortunately I
> have no connectivity (networking) available.
> >
> > > ifconfig
> > lo Link encap:Local Loopback
> > inet addr:127.0.0.1 Mask:255.0.0.0
> > inet6 addr: ::1/128 Scope:Host
> > UP LOOPBACK RUNNING MTU:65536 Metric:1
> > RX packets:2720 errors:0 dropped:0 overruns:0 frame:0
> > TX packets:2720 errors:0 dropped:0 overruns:0 carrier:0
> > collisions:0 txqueuelen:1
> > RX bytes:206720 (201.8 KiB) TX bytes:206720 (201.8 KiB)
> >
> > What's need to be included within local.conf to enable networking?
>
> its possible that some modules are missing. Try using core-image-base
> and see if that is any better. then we can see what the difference is
>
> > --
> > _______________________________________________
> > yocto mailing list
> > yocto at yoctoproject.org
> > https://lists.yoctoproject.org/listinfo/yocto
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.yoctoproject.org/pipermail/yocto/attachments/20181217/c9b15497/attachment.html>
More information about the yocto
mailing list