[meta-ti] proper recipe to build for BBB using the meta-ti layer?

[Robert P. J. Day]

On Mon, 8 Jul 2013, Tom Rini wrote:

> On Sun, Jul 07, 2013 at 08:00:05AM -0400, Robert P. J. Day wrote:
>
> > U-Boot SPL 2013.01.01 (Jul 06 2013 - 18:41:10)
> > OMAP SD/MMC: 0
> > ** Partition 1 not valid on device 0 **
> > spl: fat register err - -1
> > ### ERROR ### Please RESET the board ###
> >
> >   this is exactly the same SD card i was using with meta-beagleboard
> > generated image files. everything else about the build seemed fine.
> > can someone verify a known good recipe for this? is there
> > something different about the creation of the SD card? i'm currently
> > doing another build from scratch to see if i messed anything up.
>
> Can you see if backporting
> http://git.denx.de/?p=u-boot.git;a=commitdiff;h=9d956e0fefa39ba49250f61e3c7aa3dadafdb7fd
> fixes the problem?  It should apply cleanly.  Thanks!

  i'll give that a shot this evening and let you know. just to recap,
i used OE and the meta-beagleboard layer to build for my BBB and
copied to the first (bootable FAT) partition nothing but the MLO and
u-boot.img images, and that let me boot to u-boot, which is all i was
after.

 i then did an OE build using meta-ti, copied *those* generated MLO
and u-boot.img files to the same SD card, and promptly got the error
above. so that would suggest that the meta-beagleboard layer has
something equivalent to that patch, while meta-ti doesn't.

  anyway, will report back with results ASAP.

rday

-- 

========================================================================
Robert P. J. Day                                 Ottawa, Ontario, CANADA
                        http://crashcourse.ca

Twitter:                                       http://twitter.com/rpjday
LinkedIn:                               http://ca.linkedin.com/in/rpjday
========================================================================