[meta-ti] proper recipe to build for BBB using the meta-ti layer?

[Tom Rini]

On Mon, Jul 08, 2013 at 02:30:47PM -0400, Robert P. J. Day wrote:
> On Mon, 8 Jul 2013, Tom Rini wrote:
> 
> > On Sun, Jul 07, 2013 at 08:00:05AM -0400, Robert P. J. Day wrote:
> >
> > > U-Boot SPL 2013.01.01 (Jul 06 2013 - 18:41:10)
> > > OMAP SD/MMC: 0
> > > ** Partition 1 not valid on device 0 **
> > > spl: fat register err - -1
> > > ### ERROR ### Please RESET the board ###
> > >
> > >   this is exactly the same SD card i was using with meta-beagleboard
> > > generated image files. everything else about the build seemed fine.
> > > can someone verify a known good recipe for this? is there
> > > something different about the creation of the SD card? i'm currently
> > > doing another build from scratch to see if i messed anything up.
> >
> > Can you see if backporting
> > http://git.denx.de/?p=u-boot.git;a=commitdiff;h=9d956e0fefa39ba49250f61e3c7aa3dadafdb7fd
> > fixes the problem?  It should apply cleanly.  Thanks!
> 
>   i'll give that a shot this evening and let you know. just to recap,
> i used OE and the meta-beagleboard layer to build for my BBB and
> copied to the first (bootable FAT) partition nothing but the MLO and
> u-boot.img images, and that let me boot to u-boot, which is all i was
> after.

Strange.  meta-beagleboard is on v2013.04 which doesn't have that
change.

>  i then did an OE build using meta-ti, copied *those* generated MLO
> and u-boot.img files to the same SD card, and promptly got the error
> above. so that would suggest that the meta-beagleboard layer has
> something equivalent to that patch, while meta-ti doesn't.
> 
>   anyway, will report back with results ASAP.

If it fails, can you dd off the card, compress it and share a copy with
me off-list (I can provide a dropbox drop spot if needed), thanks!

-- 
Tom