[meta-ti] OMAP5: Booting build output

[Ian Wisbon]

Chase,

Thanks - I have mine set to the same:

off-on-off-on

and still no luck booting. I also tried the reverse just in case I was
backwards/upside-down; despite the same SD card booting an OMAP4 Panda,
and replacing with OMAP5 MLO and u-boot.img, I see nothing on the
console whatsoever. Not even a junk character implying an incorrect
baudrate, etc. The USBBOOT functionality seems to work, so I don't
believe the board to be non-functional.

I'll sit tight for a while and see what else is committed. Thanks for
your assistance!


> > 
> > Does the SYSBOOT switch dictate whether the SD is used for
> > booting? If
> > so, what is the correct setting? I've previously attempted to
> > boot
> > using an SD card formatted as necessary for the OMAP4 Panda, but
> > have
> > been unsuccessful - I assumed a similar FAT format would be
> > required
> > for MLO/u-boot.img
> 
> My sysboot switch is off on off on and I'm booting from SD.
> 
> You can use the same SD format at omap4.  Just replace the kerel and
> bootloader, add the boot.scr and dtb file.
> 

Regards,

--
---
Ian Wisbon
Support Manager
Timesys Corporation