[meta-ti] OMAP5: Booting build output

[Maupin, Chase]

> -----Original Message-----
> From: Ian Wisbon [mailto:ian.wisbon at timesys.com]
> Sent: Thursday, March 28, 2013 4:35 PM
> To: Maupin, Chase
> Cc: meta-ti at yoctoproject.org
> Subject: Re: [meta-ti] OMAP5: Booting build output
> 
> Chase,
> 
> Thanks - I have mine set to the same:
> 
> off-on-off-on
> 
> and still no luck booting. I also tried the reverse just in case
> I was
> backwards/upside-down; despite the same SD card booting an OMAP4
> Panda,
> and replacing with OMAP5 MLO and u-boot.img, I see nothing on the
> console whatsoever. Not even a junk character implying an
> incorrect
> baudrate, etc. The USBBOOT functionality seems to work, so I
> don't
> believe the board to be non-functional.

Are you connected to ttyUSB0 or ttyUSB1?  For my board the serial is ttyUSB0.

> 
> I'll sit tight for a while and see what else is committed. Thanks
> for
> your assistance!
> 
> 
> > >
> > > Does the SYSBOOT switch dictate whether the SD is used for
> > > booting? If
> > > so, what is the correct setting? I've previously attempted to
> > > boot
> > > using an SD card formatted as necessary for the OMAP4 Panda,
> but
> > > have
> > > been unsuccessful - I assumed a similar FAT format would be
> > > required
> > > for MLO/u-boot.img
> >
> > My sysboot switch is off on off on and I'm booting from SD.
> >
> > You can use the same SD format at omap4.  Just replace the
> kerel and
> > bootloader, add the boot.scr and dtb file.
> >
> 
> Regards,
> 
> --
> ---
> Ian Wisbon
> Support Manager
> Timesys Corporation