[meta-xilinx] microZed using meta-topic

[Alan DuBoff]

Mike,

I am going to look at this sometime this week.

I haven't dropped off the map, was just taking a slight b!T@# slap for not
getting the documentation done on setting up the zedboard...I was supposed to
do that before jumping into the microZed...:-/

I think the client is happy now and hoping to look at this microZed build
again this week.

I'll be investigating what you mention below, ezynq, and the meta-xilinx layer.

ajd

On Sat, March 1, 2014 2:19 am, Mike Looijmans wrote:
> There's no micro-zed in the meta-topic layer, but it should not be hard
> to add it.
>
> Copy or create a microzed.conf in the conf/machine directory so you can
> say "MACHINE=microzed".
>
> Create an FPGA design and put it in a repository somewhere. Use this as
> "provider" for virtual/xilinx-sdk which is used to build the bootloader.
>
> Configure the kernel.
>
> That's about it...
>
>
> On 03/01/2014 07:54 AM, Alan DuBoff wrote:
>> Mike,
>>
>> Is it possible to build for microZed using the meta-topic layer ?
>>
>> I got 2 microZed boards today, one 010 and one 020. Both are rev. F01 which
>> I
>> think is pretty current.
>>
>> I'd like to boot from SD card as I am doing on the zedboard.
>>
>> Is this possible at this time with the meta-topic layer?
>>
>> I don't see a specific machine type for the microZed.
>>
>> I tried to boot my zedboard image on SD card, but that didn't work.
>>
>> I saw there was a microblazee1 machine type in meta-yocto, but that won't
>> work
>> on the microZed I don't think, will it?
>>
>> I hate to go back to meta-yocto at this point after pulling my hair out over
>> the zedboard with it like I did...
>>
>> Any advice?
>>
>
>
> --
> Mike Looijmans - Topic Automation
>


-- 
Cheers,
Alan