[meta-xilinx] Thud release update

[Manjukumar Harthikote Matha]

Hi Luca,

> -----Original Message-----
> From: Luca Ceresoli [mailto:luca at lucaceresoli.net]
> Sent: Wednesday, December 12, 2018 8:31 AM
> To: Manjukumar Harthikote Matha <MANJUKUM at xilinx.com>; meta-
> xilinx at yoctoproject.org
> Subject: Re: [meta-xilinx] Thud release update
> 
> Hi Manjukumar,
> 
> On 29/11/18 18:07, Manjukumar Harthikote Matha wrote:
> > Hi All,
> >
> > Thud release branch is under-testing as of now, we will start sending patches next
> week and start merging to master:
> > Please check the tree here:
> > https://github.com/Xilinx/meta-xilinx/commits/master-next
> >
> > Major changes:
> > meta-xilinx-standalone layer to support building toolchain for MB and pmu-
> firmware
> > Proposal was sent here:
> > https://lists.yoctoproject.org/pipermail/meta-xilinx/2018-September/004051.html
> >
> > There are two ways to build pmu-firmware: One using multiconfig and other as
> two separate distros
> >
> > 1) multiconfig way:
> > 	- You need to add the dependency in the image file, for example in core-
> image-minimal you will need
> > 	do_image[mcdepends] = "multiconfig:zcu102:pmu:pmu-
> firmware:do_deploy"
> >
> >
> > 	- Add conf/multiconfig in the build directory and create pmu.conf and
> zcu102.conf under conf/multiconfig
> >                pmu.conf  consists of
> > 	MACHINE="zynqmp-pmu"
> > 	DISTRO="xilinx-standalone"
> >     	GCCVERSION="7.%"
> >     	TMPDIR="${TOPDIR}/pmutmp"
> >
> > 	zcu102.conf consists of
> > 	MACHINE="zcu102-zynqmp"
> >     	DISTRO="poky"
> >                - In local.conf multiconfig is enabled by: BBMULTICONFIG ?= "zcu102
> pmu"
> > 	- bitbake multiconfig:zcu102:core-image-minimal
> >
> > This will build pmu-firmware in   build/pmutmp and all the linux images in build/tmp
> 
> [Disclaimer: I did not double-check everything I state below since it
> takes hours for each test]
> 
> I tried this setup and building u-boot-xlnx fails:
> 
>   $ bitbake multiconfig:zcu102:core-image-minimal
>   [...]
>   Cannot read
> ../../../../../../pmutmp/deploy/images/zynqmp-pmu/pmu-firmware-zynqmp-pmu.bin
> 
> This can be reproduced with the attached script.
> 

From script it seems you are missing do_image[mcdepends] = "multiconfig:zcu102:pmu:pmu-firmware:do_deploy" in your image file?
I think you could also add in local.conf

Thanks,
Manju

<...>