[poky] Booting BeagleBoard

[Gary Thomas]

On 02/12/2011 08:01 AM, Koen Kooi wrote:
>
> Op 12 feb 2011, om 15:52 heeft Gary Thomas het volgende geschreven:
>
>> I have a BeagleBoard C3 (not the new xM).  Trying to run the
>> latest Poky ran into some problems:
>>
>> * The boot commands in README.hardware are no longer accurate
>>   for the 2.6.37 (linux-yocto) kernel.  At least you need to
>>   use ttyO2 for the serial console.
>> * There is no video?  /dev/fb0 is not being created.
>>
>> I know that the previous (Angstrom based) 2.6.32 kernel had
>> lots of additions which support video (DSS subsystem) and
>> also camera (ISP).  Has this support been ported forward
>> into the Yocto kernel?
>
> Even better, there is a proper BSP with beagleboard support: http://gitorious.org/angstrom/angstrom-layers/commits/master

How is this used?  I tried just adding a pointer to that tree
in my conf/bblayers.conf.  I also tried moving that tree into
my poky sources at the same level as meta-emenlow, etc.  Both
attempts immediately yielded this error:
   ERROR: Unable to parse conf/bitbake.conf: Could not include required file conf/machine/include/omap3.inc

Perhaps you can give some guidance for how to use this?

Thanks

-- 
------------------------------------------------------------
Gary Thomas                 |  Consulting for the
MLB Associates              |    Embedded world
------------------------------------------------------------