[poky] Booting BeagleBoard

[Koen Kooi]

Op 13 feb 2011, om 15:57 heeft Gary Thomas het volgende geschreven:

> On 02/12/2011 08:01 AM, Koen Kooi wrote:
>> 
>> Op 12 feb 2011, om 15:52 heeft Gary Thomas het volgende geschreven:
>> 
>>> I have a BeagleBoard C3 (not the new xM).  Trying to run the
>>> latest Poky ran into some problems:
>>> 
>>> * The boot commands in README.hardware are no longer accurate
>>>  for the 2.6.37 (linux-yocto) kernel.  At least you need to
>>>  use ttyO2 for the serial console.
>>> * There is no video?  /dev/fb0 is not being created.
>>> 
>>> I know that the previous (Angstrom based) 2.6.32 kernel had
>>> lots of additions which support video (DSS subsystem) and
>>> also camera (ISP).  Has this support been ported forward
>>> into the Yocto kernel?
>> 
>> Even better, there is a proper BSP with beagleboard support: http://gitorious.org/angstrom/angstrom-layers/commits/master
> 
> How is this used?  I tried just adding a pointer to that tree
> in my conf/bblayers.conf.  I also tried moving that tree into
> my poky sources at the same level as meta-emenlow, etc.  Both
> attempts immediately yielded this error:
>  ERROR: Unable to parse conf/bitbake.conf: Could not include required file conf/machine/include/omap3.inc
> 
> Perhaps you can give some guidance for how to use this?

http://thread.gmane.org/gmane.linux.distributions.angstrom.devel/4698/focus=4700